All news articlesNMC RESEARCH
CategoryTECH
RegionsUSAWORLD
ContinentsNorth America
AI-generated editorial illustration based on the published article topic; not a documentary photograph.

FAA pauses Juniper router installations after US flight ground stop

Loading statistics…

The US aviation regulator has paused new Juniper router installations while it investigates the communications failure behind a nationwide halt to flight departures.

Review information is loading.

The Federal Aviation Administration (FAA) told CNN it was pausing installation of the new telecommunications routers while it investigates the disruption. The agency also says it disabled the broadcasting function on all the new routers as a precaution. That measure concerns one function, rather than a shutdown of every installed router.

The nationwide ground stop halted most departures for more than four hours on 13 November. The FAA said communications and radar feeds became unstable at 17 of its 22 en-route air traffic control centres. Flights resumed at 8.15pm Eastern time.

The FAA says an initial investigation identified two possible sources of excessive data traffic: a radar site in Amarillo, Texas, and a radio communications site in El Dorado, Arkansas. Network provider L3Harris had been working at the Arkansas site, including installing a new router. The agency says the network stabilised after the two sites were blocked, but it and L3Harris are still investigating the root cause.

Transport Secretary Sean Duffy said on 14 November that a router had begun flooding others with connection attempts during work to replace copper lines with fibre. He said officials had not determined whether the fault lay with the contractor’s work or the router itself.

Juniper’s parent company, HPE, told technology publication CRN that, based on what it knew and had been told, its equipment was working as configured. It said the FAA was assessing the configuration and performance of the infrastructure involved.

Democrats on the Senate commerce committee have called for a pause in deployment until the FAA demonstrates that the devices are ready for safe use. In a letter dated 16 November, they said that, based on information from L3Harris, the transition involved 3,648 Juniper routers, of which 400 had been installed and 69 were operational.

FAA administrator Bryan Bedford has described the router replacements as routine maintenance of an older network, separate from a broader air traffic control modernisation programme.

Sign in to give this article a thumbs up or down.

About this discussion and AI questions

Private test discussion. Comments are readers’ views and are not yet automatically fact-checked. Editing is available for 60 seconds after posting.

Sign in with a confirmed reader account and choose a username to read comments and participate.

Sorting applies to top-level comments; replies remain oldest first. New comments and likes can change the order. Refresh for the current ranking.

Loading comments…